Kitchen/Cutlery Box to fit to drawers

My wife found a similar part at some chinese vendor to place kitchen tools needed while cooking close to the workplace. This is hooked to the top edge of a drawer. Needless to say, this was cheap soft plastic that wore out fast, and eventually broke.

So I made a simple replacement.

Details:

I used PLA, but if placed closer to the cooker, one should use PETG or a material less susceptible to heat. 0,2mm and 15-30% infill should be stable enough to even keep higher weights - you cannot sit on it, of course :-) Note, as it is printed upside down (bottom side up), there is a problem with long overhangs. I added a grid at the bottom, but this won't produce a smoth bottom. Thus, the second part is a rectangualr inlay to be glued to the inside of the box, which makes the box even more stable as well.

Design and description by hveit01 , licensed CC-BY-SA.