Kitchen Pot/Pan Organizer Brackets

We acquired some used kitchen shelf pull-out organizer racks for our pots and pans. Only problem was that the plastic clips to support the vertical dividers either were missing or broke easily under the weight of the pots/pans. Solutions: 3d print something better!

This design uses a sliding dovetail joint to hold the bracket onto a 6 mm rod on the pull-out base of the organizer. A hole in the bracket then supports the 5 mm diameter inserts for the upright organizers. If your organizer has similar rod dimensions, you are good to go. If not, contact me and I can provide you the Onshape files these were made from to change the hole dimensions to match your setup.

Printed in PLA+ and they seem to be just fine supporting our many cast-iron skillets.

Design and description by MBartlett , licensed CC-BY.