Promethean ActivPanel 9 Pen Clip (for Lanyards)

“Can I have a new pen for my Promethean board, I've lost my old one”.

If only teachers would look after the lovely equipment IT buy them…

This clip is designed to attach a Promethean Pen to a standard lanyard clip, reducing the number of times you need to buy - or print - them a new one.

This clip fits both the AP9-PEN-A and AP9-PEN-B (-B shown for reference):

Printing the clip

I chose to print in Prusament PETG. I suspect if users are removing the pen from their clips regularly, PLA would wear out.

• 0.25mm layer height • Supports: None • 0% infill

Print Time: 20 Minutes

*image shows supports, but testing has shown that you can get away without using them. Saves around 3 minutes on your print too.

Assembly & Usage

• Push the pen into the clip until it snaps into place. • Attach the clip to your favourite lanyard.

Also fits Sharpie pens quite nicely too:

Stylish Arduino Education Lanyard not included.

Design and description by creativemario , licensed CC-BY.