Train / Dept. 56 Model Street Lamp

I resized the original design to be 1:48 scale so that 3.5" is equal to a 14 foot high street lamp. This size matches the Dept. 56 Snow Village houses. I increased the size of the hole through the middle so that wires could be fed through.

I've just added the same lamp scaled for HO train layouts which is 1:87 instead of the 1:48 of Dept. 56 Snow Village Houses. The lamp parts for HO scale have "HO" in the name. The HO scale lamp design has a hole down the middle that will accept the grain of wheat lamps referenced below.

I was able to print the glass section in clear PETG. This material is harder to print than PLA. If you have problems, white PLA also works for the glass section.

This is the link for the mini grain of wheat bulbs I used. https://www.amazon.com/gp/product/B01A6B5DYK

Print Settings

Printer:

HyperCube

Rafts: No

Supports:

No

Resolution: 0.1mm

Infill:

70%

Filament:

HatchBox PLA Grey

Notes

I did use a brim to make sure the post stuck to the bed.

Category: DIY

Design and description by Plexi , licensed CC-BY.