Ikea Galant Drawer Organizer 1x2

This is a simple, modular drawer organizer for the Ikea Galant file drawer units. This thing is the 1x2 organizer that is 1/2th the width of the drawer. Print 2 of these to fill one row across the drawer - or mix and match with the 1x1 organizer (as shown in the photo) for endless possibilities! (The 1x1 organizer is available in a different thing)

The organizer is short enough to fit in the shortest Galant file drawer. Deploying them two-across will have a slight gap on each side.

This organizer has slots in the bottom to allow feet to be printed and glued into place with cyanoacrylate glue. The feet should be printed with a flexible filament such as NinjaFlex 85A TPU. This will make the feet grippy to limit the sliding the organizer will do when you open or close the drawer. However, if you do not have flexible filament, it would be better to omit the feet. This gives the organizer more contact with the drawer to limit sliding.

Print Settings

Printer:

Sovol SV01

Rafts: No

Supports:

No

Infill: 15%

Filament: Coex PLA Metallic Grey

Notes

Feet should be printed with a flexible filament such as NinjaFlex 85A TPU.

Category: Organization

Design and description by benrr101 , licensed CC0.