SKADIS Nerf clip/Talon mag Holder

A SKADIS wall mounted magazine/clip holder for your Nerf armory.

Features

• Holds 4 talon or 4 full length clips • Holder can be mounted upside down • Mags can be mounted in either direction • Fence-like wall decreases filament use and print time • Exposed top so you can load without removing from the wall

Printing

Print with supports for the back of the holder (the part that attaches to the pegboard). You can use the support painter for that. If your printer is good, you might get away with not needing supports, but it wasn't really designed for that.

I recommend 4 walls, 15% gyroid infill. Again, you could probably get away with less.

Usage

Print two Support Clips and your choice of clip holder.

Place both clips on the pegboard first (curved side down), slide the holder in from the top, and push top of the clips in to secure the holder. Reverse the steps to remove.

Magazines attach to the holder from the flat side. You may need to pull with some strength to get the magazines out, depending on your tolerances, but the Secure Clip System should hold enough for you to pull it out, even with force.

Full-length magazines come with a lip to prevent you from jamming the magazine too deep. This lip does not exist on talon magazines, so you may find they would go deeper than you'd like. Just be a bit more intentional with the way you put talons in the holder.

Misc

I made these for my own setup and just decided to put them out here, so don't expect the .step and .f3d files to be pretty.

That's also the reason only 4-mag configurations are available. The SKADIS pegboard allows for enough space to fit 2-full-length and 3-talon configurations, but only those. Tell me if you want to see me make those too, right now I've moved on to other things.

All feedback is appreciated!

Design and description by XYPH , licensed CC-BY-SA.