Sunglasses Car Visor Clip

Introducing my latest 3D model: a clip that attaches your sunglasses to your car's sunvisor, keeping them within easy reach. This easy-to-print accessory is designed for quick assembly and installation, adding a touch of convenience to your driving experience. Never lose track of your sunglasses again! 😎🚗✨

##

Thingiverse

This is my model originally posted on Thingiverse!

If you have questions about materials or want a variation of this there is a ton of discussion over there.

Overview

I designed this clip to clip my sunglasses to my cars sun visor when not in use. It works very well for my Ray-Bans. I have also provided the f3d file which you could use to make some adjustments to tailor the part for your sunglasses.

Print Recommendations

For hot climates, PLA will likely melt a bit and cause the model to bend. I would highly recommending printing this model in ASA, this Polymaker ASA works well for me¹. I also would recommend using a higher percentage infill so that there is more plastic if it does soften.

• Layer Height: 0.15-0.2mm Quality • Material: ASA¹ • Infill: 30% or higher • Supports: None

V2

I also posted a new version not necessarily to replace this but its a different design that should be better at holding some sunglasses and not warping quite as much.

V2: https://www.printables.com/model/220054-sunglasses-car-sun-visor-clip-v2

Category: Organization

1) This post contains affiliate links, any link marked with ¹ is an affiliate link. Using these links helps support my work!

Design and description by arcanelayers , licensed CC-BY.